Showing 1730–1740 of 10070 results

RAM Mounts RAM-316-TU mounting kit

"The RAM-B-108BU-HUM1 consists of a 1"" diameter rubber ball connected at a right angle to a v-shaped base. The RAM-B-108BU-HUM1 accommodates rails from 1.0"" to a maximum of 2.1"" in diameter. To mount the RAM-B-108BU-HUM1 base, place the saddle shaped plate on the rail then wrap the metal clamp strap around the rail and plate. Tighten the screw knob on the metal strap with a screw driver until the strap has a firm hold on the rail. The RAM-B-108BU-HUM1 is an alternative mounting base for Beechcraft airplanes with a ""throw over yoke""."

RAM Mounts RAM-B-138U-C mounting kit

"The RAM-B-149U consists of a stainless steel u-bolt base, double socket arm and diamond adapter base. The diamond adapter base has a hole pattern that matches the industry standard AMPS hole pattern and will connect to a large variety of RAM Mount and third party cradles. The mount is designed with a RAM 1"" diameter patented rubber ball and socket system that has adjustment points at both ends of the double socket arm; this allowing for almost infinite adjustment and perfect viewing angles."

"The RAM-B-149Z-QU1 consists of a zinc coated u-bolt base and double socket arm. The mount is designed with a RAM 1"" diameter patented rubber ball and socket system that has adjustment points at both ends of the double socket arm. The zinc coated u-bolt base Accommodates rails from 0.5"" to 1"" in diameter and includes black cover caps to be placed over the exposed ends of the u-bolt. This is a universal mounting solution for the RAM cradles with a 1 inch ball."

"The RAM-B-166-C-202U consists of a 3.3"" suction cup twist lock base, LONG double socket arm and round base that contains the universal AMPs hole pattern. The suction cup base is designed to have a strong hold on glass and non-porous plastic surfaces, including RAM adhesive disks. The mount is designed with a RAM 1"" diameter patented rubber ball and socket system that has adjustment points at both ends of the double socket arm; this allowing for almost infinite adjustment and perfect viewing angles. The hole pattern found on the round base adapter will connect to most RAM cradles and 3rd party cradles."

RAM Mounts RAM-D-200-1OFU mounting kit

"The RAM-D-101U-2461 consists of a 3.68"" diameter round base, STANDARD length double socket arm and 3.625"" square plate with the VESA hole pattern. The VESA plate contains a 75mm X 75mm hole pattern. The 3.68"" diameter round base has pre-drilled holes, including two holes at 180 degrees and three holes at 120 degrees. Designed into the mount is a 2.25"" diameter patented rubber ball and socket system with adjustment points at both socket ends of the arm. Rubber ball and socket technology allows for almost infinite adjustment and perfect viewing angles."

RAM Mounts RAM-D-162V-MC4 mounting kit

"The RAM-B-309-2U connects to your handlebar clutch/brake clamp, left or right side, and holds two 1"" diameter mounting ball. The ball that is connected between the hole centers is removable. The base fits the control clamps on your motorcycle with 40mm x 6mm stainless steel hardware, provided in the kit. To see if the RAM-B-309-2 base will mount to your motorcycle, check the hole spacing of the base against your clutch/brake reservoir. The holes centers have a minimum width of 0.94"" and a maximum of 1.58""."